![]() ![]() Rotate the thumbturn 90° toward the hinges.Push the key and cylinder into the thumbturn.Key Override can be used to gain access when the battery is completely dead, when no valid User Code is known or when Lock Override is engaged. We don’t recommend them because they don’t give you a lot of time to change your batteries before the lock is completely dead. Lithium batteries may have a longer life, but when they begin to fail, they fail quickly. Re-tuck wires so they will not be crimped.Use a high-quality alkaline 9 volt battery for replacement. This will ensure continued reliable operation. Replace the batteries in your lock at the same time each year that you test and replace the batteries in your smoke alarms. Rotate the thumbturn toward the hinges.» If lighting is low, press the Schlage button to illuminate the keypad before beginning. ![]() See Enable or Disable Lock & Leave on page 12. * If the Turn Lock feature is disabled, a valid User Code must be entered to lock the door. Rotate the thumbturn away from the hinges.MODEL BE365 Locking and Unlocking From the outside FE595 ONLY: Used to put the lock in a locked or unlocked state.Used only in emergency situations to unlock the lock.The outside lever can be rotated at any time, but will only retract the latch when the lock is unlocked.The inside lever can be rotated at any time to retract the latch.Programming Guide on page 10 and Locking and Unlocking on page 8 for more information. Used to enter codes for programming and unlocking.Models FE575 (Auto Lock) and FE595 (Flex Lock) Used to unlock the lock after a valid User Code has been entered, or to lock the lock after the Schlage button has been pressed.See Programming Guide on page 10 and Locking and Unlocking on page 6 for more information. But if you don’t already have one of these devices, you either have to buy one or borrow one from somebody for long enough to get the locks installed.For technical documents and videos, visit Then you plug the AP device in close to the lock, and cable the hub to that. Seriously, I have a 50 foot one I use for some of these situations.Ī far easier method is to get a Wi-Fi access point device that has an ethernet port on the side. If your hub model is one of the ones that has to be cabled to your router, there are two ways to bring it closer to the lock. Options for bringing the hub close to the lock temporarily It may just be a defective device, it happens. If even those instructions don’t work, you’ll need to contact Schlage support. ![]() The Schlage locks all seemed to pair fine but only one is reporting and locks/unlocks from the app. Likewise, if I am at the device itself it will open or close just fine, but I have to go back to the list of things to get it to carry out the second command (whether it be open or close). The garage door opener paired just fine, but when I oped the door from the ST app, it opens just fine but when I try to close it, it will not close until I actually click on the device to check its status. I also have three Schlage Z-Wave Lever locks (FE599 I believe?) and a Linear Z-Wave Garage door opener.Įverything went perfectly until I got to the locks and garage door opener. I have many GE light switches and a few GE outlets/receptacles. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |